Select The Results To Output; Reflect In Total Judgement - Omron FQ2-S Series User Manual

Selection item Setting
Sorting method Corr. ascending order (ascending order of correlation
value)
Corr. descending order (descending order of correlation
value) (default)
Pos.X ascending order (ascending order of position X)
Pos.X descending order (descending order of position X)
Pos.Y ascending order (ascending order of position Y)
Pos.Y descending order (descending order of position Y)

Select the Results to Output

You can use multiple conditions to determine which results to output from all the objects detected with a
correlation at the candidate level or higher.
Only the results that meet all the specified conditions are output.
[Inspect] − [Inspection] − [Search] − [Modify] − [Details] Tab Page − [Meas. Parameter]
1
Press [Extraction condition] and adjust the candi-
date level so that only objects higher than a certain
correlation are detected.
2
If [Multi-point output] is set to [Yes], you can specify
the output conditions for more than one result. (Ex-
traction X/Y and Detection count)
Extraction condi- Range
tion
Candidate level Range: 0 to 100
Defaults: Lower limit: 70, Upper limit: 100
Extraction X Range:-99999.9999 to 99999.9999
Defaults: -99999.9999, 99999.9999
Extraction Y Range:-99999.9999 to 99999.9999
Defaults: -99999.9999, 99999.9999
Detection count Range: 1 to 32
Default: 32
Note
The processing time changes if you change the candidate level.

Reflect in Total Judgement

You can specify whether to reflect the judgement results of an inspection item in the overall judgement. (The
default is to reflect them.)
[Inspect] − [Inspection] − [Add item.] − [Search] − [Details] Tab Page − [Output parameter]
FQ2-S/CH User's Manual
Description
Sorts the results in order from the smallest correlation
to the largest.
Sorts the results in order from the largest correlation to
the smallest.
Sorts the results in order from the smallest measure-
ment X position to the largest.
Sorts the results in order from the largest measure-
ment X position to the smallest.
Sorts the results in order from the smallest measure-
ment Y position to the largest.
Sorts the results in order from the largest measure-
ment Y position to the smallest.
Description
Outputs only objects with a correlation that is higher
than the specified candidate level.
Results are output only for objects with a measured X
coordinate that is within this range.
Results are output only for objects with a measured Y
coordinate that is within this range.
Sets the maximum number of detection results to out-
put.
Inspecting with the Search Inspection Item
151