Measurement Data That Can Be Used For External Outputs And Calculations; Measurement Data That Can Be Logged For Edge Width; Errors - Omron FQ2-S Series User Manual

Measurement Data That Can Be Used for External Outputs and Calculations

The following values can be output to external devices or used in calculations as measurement data.
Expression text string
JG Judgement
W Edge width
SW Ref. edge width (reference
edge width)
DF D. edge width (difference in
edge width)
4-17 Calculations and Judgements Using Inspection Item Data: p. 213

Measurement Data That Can Be Logged for Edge Width

The following values can be logged as measurement data.
Measured item Range of value
Judgement 0: Judgement is OK,
−1: Judgement is NG,
−13: Teaching not performed error,
−14: Figure not registered error,
−15: Out of range error
−99999.9999 to 99999.9999
Edge Width (edge in
width)
*1 When logging data is output, the data is output in the order of the above table. If more than one item is stored, results are output for each
model.
7-6 Logging Measurement Data and Image Data: p. 269

Errors

Errors in Teaching
A teaching error message will appear if the edge position cannot be detected when teaching. Perform the
following.
• If the color of the measurement object has changed from the specified color, set the color again and try
teaching again.
• If there is an edge and it cannot be detected, adjust the [Noise level] on the [Details] Tab Page and try
teaching again.
If an edge is not detected when teaching, 0 will be registered as the reference width. If the result is OKed when
there is not edge, set the judgement parameters for a reference position of 0.
FQ2-S/CH User's Manual
Data name
This is the judgement result.
Edge width
This is the reference edge width from
when the model was registered.
This is the difference between the ref-
erence edge width and the measured
edge width.
Description
This is the measurement judgement results.
This is the difference between the reference width and the measured
edge width.
Description
−2: No judgement (not measured),
0: Judgement is OK,
−1: Judgement is NG,
−13: Teaching not performed error,
−14: Figure not registered error,
−15: Out of range error
0 to 99999.9999
0 to 99999.9999
0 to 99999.9999
Inspecting with the Edge Width Inspection Item
Data range
185