6
Select [Internet Protocol Version 4 (TCP/IPv4)] in [Local
Area Connection Properties], and click [Properties].
7
Select the Use the following IP address Option and en-
ter the following IP address and subnet mask.
• IP address: 10.5.5.101
• Subnet mask: 255.255.255.0
8
Click the [OK] Button. This completes the settings.
Connections on Existing Networks
Set the Ethernet settings of the Sensors and the computer (PC Tool) to the same settings as the existing
network. Refer to Connecting to Sensors from the Touch Finder on page 59 for the IP address settings in the
Sensors.
Note
• If you connect the PC Tool to a Sensor on a different network through a router, set fixed IP addresses.
• When connecting by EtherNet/IP or PROFINET, set fixed IP addresses for the Sensors.
FQ2-S/CH User's Manual
61
Setting Up Ethernet