Omron FQ2-S Series User Manual page 127

Note
You can use the menu commands that are displayed for
resulted from teaching.
[Insp. region]: You can change the measurement region.
[Camara setup]: You can adjust the Camera focus, brightness, and other factors to input a better image.
Adjusting Image Quality: p. 66
[Meas. Parameter]: You can change the type of code to read, the read settings, etc.
Detailed Parameters: p. 127
[Continuous test]: You can start test measurements of displayed images for the settings that were taught.
Performing Test Measurements: p. 228
Step 3 Setting Verification Conditions
You can register a character string from a barcode to use it to verify that the character string that was read from
a barcode matches the registered character string.
You can register up to 32 character strings for verification in the master data.
You can verify the character string in the inspection against up to 32 character strings that are registered in the
master data.
The verification result is saved in an external reference parameter, so you can use a communications
command to output it to an external device.
External Reference Parameters: p. 335
−
[Inspect] [Inspection]
1
Press [Verification].
2
Press [Master data regist.].
3
Press the character string to register in the master
data.
4
You can use any of the following three methods to
register character strings in the master data from the
menu display.
[Auto]: Registers a character string from an actual
barcode in the master data. The procedure is
essentially the same as the procedure for
teaching in step 2.
[Manual]: Registers a character string that is entered di-
rectly in the master data. You can use a soft-
ware keyboard to register a character string
with up to 32 characters.
FQ2-S/CH User's Manual
− −
[Add item.] [Bar code]
at the right of the display to adjust the settings that
−
[Settings] Tab Page
125
Reading Bar Codes