Dell Networking N4000 Series Configuration Manual page 1170

Command
ipv6 ospf dead-interval
seconds
ipv6 ospf transmit-delay
seconds
ip ospf mtu-ignore
ipv6 ospf network
{broadcast | point-to-
point }
interface-
ipv6 ospf cost
cost
bw
bandwidth
exit
ipv6 router ospf
passive-interface {vlan
vlan-id
| tunnel
id
}
exit
exit
1170
Configuring OSPF and OSPFv3
Purpose
Set the OSPFv3 dead interval for the interface.
seconds
The
router waits to see a neighbor router's Hello packets before
declaring that the router is down (Range: 1–65535).
This parameter must be the same for all routers attached
to a network. This value should be some multiple of the
Hello Interval.
Set the OSPFv3 Transit Delay for the interface.
seconds
The
seconds it takes to transmit a link state update packet over
this interface. (Range: 1–3600 seconds)
Disable OSPFv3 MTU mismatch detection on received
database description packets.
Set the OSPFv3 network type on the interface to
broadcast or point-to-point. OSPFv3 selects a designated
router and originates network LSAs only for broadcast
networks. No more than two OSPFv3 routers may be
present on a point-to-point link.
Set the metric cost of the interface.
interface-cost
The
metric) of the OSPFv3 interface. (Range: 1–65535)
Set the interface bandwidth used in the formula to
compute link cost for an interface:
link cost = ref_bw÷interface bandwidth
bw
The
1–10000000 Kbps).
Exit to Global Configuration Mode
Enter OSPFv3 configuration mode.
Make an interface passive to prevent OSPFv3 from
tunnel-
forming an adjacency on an interface. OSPFv3 advertises
networks attached to passive interfaces as stub networks.
Exit to Global Config mode.
Exit to Privileged EXEC mode.
variable indicates the number of seconds a
variable sets the estimated number of
variable specifies the cost (link-state
variable is the interface bandwidth (Range: