Configuring Green Features - Dell Networking 7048 Configuration Manual

Command
interface
depends-on
action {down|up}
CTRL + Z
show link-dependency
group_id
[group ]

Configuring Green Features

Beginning in Privileged EXEC mode, use the following commands to
configure and monitor energy-saving features for the ports and the switch.
Command
configure
interface
interface
green-mode energy-
detect
green-mode eee
exit
Purpose
Specify the port(s) upon which the member ports are
dependent. For information about the
see the previous command description.
Specifies the action the member ports take when the
dependent link goes down.
• down—When the dependent link is down, the group
members are down (the members are up otherwise).
• up—When the dependent link goes down, the group
members are brought up (the members are down
otherwise)
Exit to Privileged EXEC mode.
View link dependency settings for all groups or for the
specified group, along with the group state.
Purpose
Enter Global Configuration mode.
Enter interface configuration mode for the specified
interface
interface. The
and number, for example gigabitethernet 1/0/3.
You can also specify a range of interfaces with the interface
range command, for example, interface range
gigabitethernet 1/0/8-12 configures interfaces 8, 9, 10, 11,
and 12.
Enable low-power idle mode on the interface.
Enable EEE low power idle mode on the interface.
Exit to global configuration mode.
Configuring Port Characteristics
interface
variable includes the interface type
variable,
477