Monitoring System Information And Configuring Logging (Cli); Viewing System Information And Enabling The Locator Led; Running Cable Diagnostics - Dell Networking 7048 Configuration Manual

Monitoring System Information and Configuring
Logging (CLI)
This section provides information about the commands you use to configure
information you use to monitor the PowerConnect 7000 Series switch. For
more information about these commands, see the
CLI Reference Guide

Viewing System Information and Enabling the Locator LED

Beginning in Privileged EXEC mode, use the following commands to view
system health and resource information and to enable the switch locator
LED.
Command
show system
show system power
show system
temperature
show memory cpu
show process cpu
unit
locate [switch
time
[time ]

Running Cable Diagnostics

Beginning in Privileged EXEC mode, use the following commands to run the
cable diagnostic tests.
NOTE:
Cable diagnostics may give misleading results if green mode is enabled
on the port. Disable green mode prior to running any cable diagnostics.
226
Monitoring and Logging System Information
at support.dell.com/manuals.
Purpose
Display various system information.
Displays the power supply status.
Displays the system temperature and fan status.
Displays the total and available RAM space on the switch.
Displays the CPU utilization for each process currently
running on the switch.
] Enable the switch locator LED located on the back panel
of the switch. Optionally, you can specify the unit to
identify within a switch stack and the length of time that
the LED blinks.
PowerConnect 7000 Series