Preconfiguring A Stack Member - Dell M6220 User Configuration Manual

Hide thumbs Also See for M6220:

Table of Contents

Preconfiguring a Stack Member

To preconfigure a stack member before connecting the physical unit to the

stack, use the show support switchtype command to obtain the SID of the

unit to be added.

The example in this section demonstrates pre-configuring a PowerConnect

7048P switch on a stand-alone PowerConnect 6348 switch.

To configure the switch:

1 View the list of SIDs to determine which SID identifies the switch to

preconfigure.

console#show supported switchtype

------ ------------------------- ----------

2 Preconfigure the 7048P switch (SID = 6) as member number 2 in the

console#configure

console(config)#stack

console(config-stack)#member 2 6

console(config-stack)#exit

console(config)#exit

Managing a Switch Stack

Switch Mode ID

M8024 M6348 M8024-k