Preconfiguring A Stack Member - Dell Networking 7048 Configuration Manual

Powerconnect 7000 series switch

Hide thumbs Also See for Networking 7048:

Table of Contents

Preconfiguring a Stack Member

To preconfigure a stack member before connecting the physical unit to the

stack, use the show support switchtype command to obtain the SID of the

unit to be added.

The example in this section demonstrates pre-configuring a PowerConnect

7048P switch on a stand-alone PowerConnect 7048R switch.

To configure the switch:

1 View the list of SIDs to determine which SID identifies the switch to

preconfigure.

console#show supported switchtype

------ ------------------------- ----------

2 Preconfigure the 7048P switch (SID = 6) as member number 2 in the

console#configure

console(config)#stack

console(config-stack)#member 2 6

console(config-stack)#exit

console(config)#exit

Managing a Switch Stack

Switch Mode ID

Show Quick Links

Table of Contents