Clustering Management Configuration - ZyXEL Communications XGS-4728F User Manual

Chapter 43 Cluster Management

43.3 Clustering Management Configuration

Use this screen to configure clustering management. Click Configuration from
the Cluster Management screen to display the next screen.
Figure 224 Management > Clustering Management > Configuration
The following table describes the labels in this screen.
Table 141 Management > Clustering Management > Configuration
LABEL
Clustering
Manager
Active
Name
VID
368
DESCRIPTION
Select Active to have this Switch become the cluster manager switch.
A cluster can only have one manager. Other (directly connected)
switches that are set to be cluster managers will not be visible in the
Clustering Candidates list. If a switch that was previously a cluster
member is later set to become a cluster manager, then its Status is
displayed as Error in the Cluster Management Status screen and a
warning icon ( ) appears in the member summary list below.
Type a name to identify the Clustering Manager. You may use up to
32 printable characters (spaces are allowed).
This is the VLAN ID and is only applicable if the Switch is set to
802.1Q VLAN. All switches must be directly connected and in the
same VLAN group to belong to the same cluster. Switches that are not
in the same VLAN group are not visible in the Clustering Candidates
list. This field is ignored if the Clustering Manager is using Port-
based VLAN.
XGS-4728F User's Guide