Port Setup - ZyXEL Communications XGS-4728F User Manual

8.7 Port Setup

Use this screen to configure Switch port settings.Click Basic Setting > Port
Setup in the navigation panel to display the configuration screen.
Figure 43 Basic Setting > Port Setup
The following table describes the labels in this screen.
Table 13 Basic Setting > Port Setup
LABEL
Port
*
Active
Name
Type
XGS-4728F User's Guide
DESCRIPTION
This is the port index number.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports.
Use this row first to set the common settings and then make adjustments
on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you
make them.
Select this check box to enable a port. The factory default for all ports is
enabled. A port must be enabled for data transmission to occur.
Type a descriptive name that identifies this port. You can enter up to 64
alpha-numerical characters.
Note: Due to space limitations, the port name may be truncated in
some web configurator screens.
This field displays 10/100/1000M for a 1000Base-T connection, 10G for
a 10 Gigabit Ethernet connection and 12G for a 10GBase-CX4 connection.
Chapter 8 Basic Setting
89