Mvr Configuration Example - ZyXEL Communications XGS-4728F User Manual

Chapter 24 Multicast
Table 64 Advanced Application > Multicast > Multicast Setting > MVR: Group
Configuration
LABEL
Add
Cancel
MVLAN
Name
Start
Address
End Address
Delete
Cancel

24.8.1 MVR Configuration Example

The following figure shows a network example where ports 1, 2 and 3 on the
Switch belong to VLAN 1. In addition, port 7 belongs to the multicast group with
VID 200 to receive multicast traffic (the News and Movie channels) from the
remote streaming media server, S. Computers A, B and C in VLAN 1 are able to
receive the traffic.
Figure 110 MVR Configuration Example
VLAN 1
A
C
212
DESCRIPTION
Click Add to save your changes to the Switch's run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
This field displays the multicast VLAN ID.
This field displays the descriptive name for this setting.
This field displays the starting IP address of the multicast group.
This field displays the ending IP address of the multicast group.
Select Delete All or Delete Group and click Delete to remove the
selected entry(ies) from the table.
Select Cancel to clear the checkbox(es) in the table.
1
2
3
B
News: 224.1.4.10 ~ 224.1.4.50
Movie: 230.1.2.50 ~230.1.2.60
Multicast VID 200
7
S
XGS-4728F User's Guide