Clustering Management Configuration - ZyXEL Communications GS1350 Series User Manual

38.3 Clustering Management Configuration

Use this screen to configure clustering management. Click Management > Cluster Management >
Configuration to display the next screen.
Figure 224 Management > Cluster Management > Configuration
The following table describes the labels in this screen.
Table 150 Management > Cluster Management > Configuration
LABEL
Clustering Manager
Active
Name
VID
Apply
Chapter 38 Cluster Management
DESCRIPTION
The following fields relate to configuring the cluster manager.
Select Active to have this Switch become the cluster manager switch. A cluster can only
have one manager. Other (directly connected) switches that are set to be cluster
managers will not be visible in the Clustering Candidates list. If a switch that was previously a
cluster member is later set to become a cluster manager, then its Status is displayed as Error
in the Cluster Management Status screen and a warning icon (
summary list below.
Type a name to identify the Clustering Manager. You may use up to 32 printable characters
(spaces are allowed).
This is the VLAN ID and is only applicable if the Switch is set to 802.1Q VLAN. All switches must
be directly connected and in the same VLAN group to belong to the same cluster. Switches
that are not in the same VLAN group are not visible in the Clustering Candidates list. This field
is ignored if the Clustering Manager is using Port-based VLAN.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
GS1350 Series User's Guide
301
) appears in the member