Configuring Vrrp Parameters; Vrrp Configuration Examples - ZyXEL Communications XGS-4728F User Manual

Table 117 IP Application > VRRP Configuration > VRRP Parameters (continued)
LABEL
Add
Cancel
Clear

38.3.4 Configuring VRRP Parameters

View the VRRP configuration summary at the bottom of the screen.
Figure 186 VRRP Configuration: Summary
The following table describes the labels in this screen.
Table 118 VRRP Configuring: VRRP Parameters
LABEL
Index
Active
Name
Network
VRID
Primary VIP
Uplink
Gateway
Priority
Delete
Cancel

38.4 VRRP Configuration Examples

The following sections show two VRRP configuration examples on the Switch.
XGS-4728F User's Guide
DESCRIPTION
Click Add to save your changes to the Switch's run-time memory.
The Switch loses these changes if it is turned off or loses power, so
use the Save link on the top navigation panel to save your changes
to the non-volatile memory when you are done configuring.
Click Cancel to discard all changes made in this table.
Click Clear to set the above fields back to the factory defaults.
DESCRIPTION
This field displays the index number of an entry.
This field shows whether a VRRP entry is enabled (Yes) or disabled (No).
This field displays a descriptive name of an entry.
This field displays the IP address and subnet mask of an interface.
This field displays the ID number of a virtual router.
This field displays the IP address of the primary virtual router.
This field displays the IP address of the uplink gateway.
This field displays the priority level (1 to 255) of the entry.
Click Delete to remove the selected entry from the summary table.
Click Cancel to clear the Delete check boxes.
Chapter 38 VRRP
323