Loop Guard Setup - ZyXEL Communications XGS-4728F User Manual

port N. The Switch will shut down port N if it detects that the probe packet has
returned to the Switch.
Figure 136 Loop Guard - Network Loop
Note: After resolving the loop problem on your network you can re-activate the
disabled port via the web configurator (see
commands (see the Ethernet Switch CLI Reference Guide).

27.2 Loop Guard Setup

Click Advanced Application > Loop Guard in the navigation panel to display the
screen as shown.
Note: The loop guard feature can not be enabled on the ports that have Spanning
Tree Protocol (RSTP, MRSTP or MSTP) enabled.
Figure 137 Advanced Application > Loop Guard
XGS-4728F User's Guide
A
N
P
Section 8.7 on page
Chapter 27 Loop Guard
89) or via
257