Configure Vlan Port Settings - ZyXEL Communications XGS-4728F User Manual

Chapter 9 VLAN
Table 17 Advanced Application > VLAN > Static VLAN (continued)
LABEL
Control
Tagging
Add
Cancel
Clear
VID
Active
Name
Delete
Cancel

9.5.4 Configure VLAN Port Settings

Use the VLAN Port Setting screen to configure the static VLAN (IEEE 802.1Q)
settings on a port. See
VLAN. Click the VLAN Port Setting link in the VLAN Status screen.
Figure 49 Advanced Application > VLAN > VLAN Port Setting
102
DESCRIPTION
Select Normal for the port to dynamically join this VLAN group using
GVRP. This is the default selection.
Select Fixed for the port to be a permanent member of this VLAN group.
Select Forbidden if you want to prohibit the port from joining this VLAN
group.
Select TX Tagging if you want the port to tag all outgoing frames
transmitted with this VLAN Group ID.
Click Add to save your changes to the Switch's run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Click Clear to start configuring the screen again.
This field displays the ID number of the VLAN group. Click the number to
edit the VLAN settings.
This field indicates whether the VLAN settings are enabled (Yes) or
disabled (No).
This field displays the descriptive name for this VLAN group.
Click Delete to remove the selected entry from the summary table.
Click Cancel to clear the Delete check boxes.
Section 9.1 on page 95 for more information on static
XGS-4728F User's Guide