Configuring Dhcp Vlan Settings - ZyXEL Communications XGS-4728F User Manual
Intelligent layer 3+ switch
Hide thumbs
Also See for XGS-4728F:
- User manual (426 pages) ,
- Specifications (2 pages) ,
- Manual (8 pages)
Table of Contents
Advertisement
37.5 Configuring DHCP VLAN Settings
Use this screen to configure your DHCP settings based on the VLAN domain of the
DHCP clients. Click IP Application > DHCP in the navigation panel, then click the
VLAN link In the DHCP Status screen that displays.
Note: You must set up a management IP address for each VLAN that you want to
configure DHCP settings for on the Switch. See
information on how to do this.
Figure 179 IP Application > DHCP > VLAN
The following table describes the labels in this screen.
Table 114 IP Application > DHCP > VLAN
LABEL
VID
DHCP Status
XGS-4728F User's Guide
DESCRIPTION
Enter the ID number of the VLAN to which these DHCP settings apply.
Select whether the Switch should function as a DHCP Server or Relay for
the specified VID. If you select Server then fields related to DHCP relay
configuration are grayed out and vice versa.
Chapter 37 DHCP
Section 8.6 on page 86
for
313
Advertisement
Table of Contents
Troubleshooting
