Configuring Dscp Settings - ZyXEL Communications XGS-4728F User Manual
Intelligent layer 3+ switch
Hide thumbs
Also See for XGS-4728F:
- User manual (426 pages) ,
- Specifications (2 pages) ,
- Manual (8 pages)
Table of Contents
Advertisement
Chapter 36 Differentiated Services
36.4.1 Configuring DSCP Settings
To change the DSCP-IEEE 802.1p mapping, click the DSCP Setting link in the
DiffServ screen to display the screen as shown next.
Figure 173 IP Application > DiffServ > DSCP Setting
The following table describes the labels in this screen.
Table 109 IP Application > DiffServ > DSCP Setting
LABEL
0 ... 63
Apply
Cancel
306
DESCRIPTION
This is the DSCP classification identification number.
To set the IEEE 802.1p priority mapping, select the priority level from the drop-
down list box.
Click Apply to save your changes to the Switch's run-time memory. The Switch
loses these changes if it is turned off or loses power, so use the Save link on the
top navigation panel to save your changes to the non-volatile memory when
you are done configuring.
Click Cancel to begin configuring this screen afresh.
XGS-4728F User's Guide
Advertisement
Table of Contents
Troubleshooting
