Arp Inspection Vlan Status - ZyXEL Communications XGS-4728F User Manual

Table 80 ARP Inspection Status (continued)
LABEL
Reason
Delete
Delete
Cancel

26.6.1 ARP Inspection VLAN Status

Use this screen to look at various statistics about ARP packets in each VLAN. To
open this screen, click Advanced Application > IP Source Guard > ARP
Inspection > VLAN Status.
Figure 128 ARP Inspection VLAN Status
The following table describes the labels in this screen.
Table 81 ARP Inspection VLAN Status
LABEL
Show VLAN range
Enabled VLAN
Selected VLAN
Apply
XGS-4728F User's Guide
DESCRIPTION
This field displays the reason the ARP packet was discarded.
MAC+VLAN: The MAC address and VLAN ID were not in the
binding table.
IP: The MAC address and VLAN ID were in the binding table, but
the IP address was not valid.
Port: The MAC address, VLAN ID, and IP address were in the
binding table, but the port number was not valid.
Select this and click Delete to remove the specified entry.
Click this to remove the selected entries.
Click this to clear the Delete check boxes above.
DESCRIPTION
Use this section to specify the VLANs you want to look at in the
section below.
Select this to look at all the VLANs on which ARP inspection is
enabled in the section below.
Select this to look at all the VLANs in a specific range in the
section below. Then, enter the lowest VLAN ID (Start VID) and
the highest VLAN ID (End VID) you want to look at.
Click this to display the specified range of VLANs in the section
below.
Chapter 26 IP Source Guard
247