ZyXEL Communications XGS-4728F User Manual page 320

Chapter 38 VRRP
Note: Routing domains with the same VLAN ID are not displayed in the table
indicated.
Figure 184 IP Application > VRRP Configuration > IP Interface
The following table describes the labels in this screen.
Table 116 IP Application > VRRP Configuration > IP Interface
LABEL
Index
Network
Authenticati
on
Key
Apply
Cancel
320
DESCRIPTION
This field displays the index number of an entry.
This field displays the IP address and number of subnet mask bit of an IP
domain.
Select None to disable authentication. This is the default setting.
Select Simple to use a simple password to authenticate VRRP packet
exchanges on this interface.
When you select Simple in the Authentication field, enter a password
key (up to eight printable ASCII character long) in this field.
Click Apply to save your changes to the Switch's run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to discard all changes made in this table.
XGS-4728F User's Guide