ZyXEL Communications XGS-4728F User Manual page 49

Table 5 Navigation Panel Links (continued)
LINK
VLAN
Static MAC
Forwarding
Static
Multicast
Forwarding
Filtering
Spanning Tree
Protocol
Bandwidth
Control
Broadcast
Storm Control
Mirroring
Link
Aggregation
Port
Authentication
Port Security
Classifier
Policy Rule
Queuing
Method
VLAN Stacking
Multicast
AAA
IP Source
Guard
Loop Guard
XGS-4728F User's Guide
DESCRIPTION
This link takes you to screens where you can configure port-based or
802.1Q VLAN (depending on what you configured in the Switch Setup
menu). You can also configure a protocol based VLAN or a subnet based
VLAN in these screens.
This link takes you to screens where you can configure static MAC
addresses for a port. These static MAC addresses do not age out.
This link takes you to a screen where you can configure static multicast
MAC addresses for port(s). These static multicast MAC addresses do not
age out.
This link takes you to a screen to set up filtering rules.
This link takes you to screens where you can configure the RSTP/MRSTP/
MSTP to prevent network loops.
This link takes you to screens where you can cap the maximum
bandwidth allowed from specified source(s) to specified destination(s).
This link takes you to a screen to set up broadcast filters.
This link takes you to screens where you can copy traffic from one port
or ports to another port in order that you can examine the traffic from
the first port without interference.
This link takes you to screen where you can logically aggregate physical
links to form one logical, higher-bandwidth link.
This link takes you to a screen where you can configure IEEE 802.1x port
authentication as well as MAC authentication for clients communicating
via the Switch.
This link takes you to a screen where you can activate MAC address
learning and set the maximum number of MAC addresses to learn on a
port.
This link takes you to a screen where you can configure the Switch to
group packets based on the specified criteria.
This link takes you to a screen where you can configure the Switch to
perform special treatment on the grouped packets.
This link takes you to a screen where you can configure queuing with
associated queue weights for each port.
This link takes you to a screen where you can activate and configure
VLAN stacking.
This link takes you to screen where you can configure various multicast
features, IGMP snooping and create multicast VLANs.
This link takes you to a screen where you can configure authentication,
authorization and accounting services via external servers. The external
servers can be either RADIUS (Remote Authentication Dial-In User
Service) or TACACS+ (Terminal Access Controller Access-Control System
Plus).
This link takes you to screens where you can configure filtering of
unauthorized DHCP and ARP packets in your network.
This link takes you to a screen where you can configure protection
against network loops that occur on the edge of your network.
Chapter 4 The Web Configurator
49