Configuring Vrrp Parameters - ZyXEL Communications XGS-4728F User Manual

Chapter 38 VRRP

38.3.3 Configuring VRRP Parameters

After you set up an IP interface, configure the VRRP parameters in the VRRP
Configuration screen.
Figure 185 IP Application > VRRP Configuration > VRRP Parameters
The following table describes the labels in this screen.
Table 117 IP Application > VRRP Configuration > VRRP Parameters
LABEL
Active
Name
Network
Virtual Router ID
Advertisement
Interval
Preempt Mode
Priority
Uplink Gateway
Primary Virtual IP
Secondary Virtual
IP
322
DESCRIPTION
Select this option to enable this VRRP entry.
Enter a descriptive name (up to 32 printable ASCII characters) for
identification purposes.
Select an IP domain to which this VRRP entry applies.
Select a virtual router number (1 to 7) for which this VRRP entry is
created.
You can configure up to seven virtual routers for one network.
Specify the number of seconds between Hello message
transmissions. The default is 1.
Select this option to activate preempt mode.
Enter a number (between 1 and 254) to set the priority level. The
bigger the number, the higher the priority.
This field is 100 by default.
Enter the IP address of the uplink gateway in dotted decimal
notation.
The Switch checks the link to the uplink gateway.
Enter the IP address of the primary virtual router in dotted decimal
notation.
This field is optional. Enter the IP address of a secondary virtual
router in dotted decimal notation. This field is ignored when you
enter 0.0.0.0.
XGS-4728F User's Guide