Configuring Private Vlan - ZyXEL Communications XGS-4728F User Manual

Chapter 30 Private VLAN

30.2 Configuring Private VLAN

Click Advanced Application > Private VLAN in the navigation panel to display
the screen as shown.
Figure 145 Advanced Application > Private VLAN
The following table describes the labels in this screen.
Table 90 Advanced Application > Private VLAN
LABEL
Active
Name
VLAN ID
Promiscuous
Ports
Add
Cancel
Clear
Index
Active
Name
VLAN
Promiscuous
Ports
268
DESCRIPTION
Check this box to enable private VLAN in a VLAN.
Enter a descriptive name (up to 32 printable ASCII characters) for
identification purposes.
Enter a VLAN ID from 1 to 4094. This is the VLAN to which this rule
applies.
Enter the number of the port(s) that can communicate with any ports in
the same VLAN. Other ports belonging to this VLAN will be added to the
isolation list and can only send and receive traffic from the port(s) you
specify here.
Click Add to insert the entry in the summary table below and save your
changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when
you are done configuring.
Click Cancel to reset the fields to your previous configuration.
Click Clear to clear the fields to the factory defaults.
This is the index number of the rule.
This shows whether this rule is activated or not.
This is the descriptive name for this rule.
This is the VLAN to which this rule is applied.
This shows the port(s) that can communicate with any ports in the same
VLAN.
XGS-4728F User's Guide