Static Route; Chapter 31 Static Route; Configuring Static Routing - ZyXEL Communications XGS-4728F User Manual

C
H A P T E R
This chapter shows you how to configure static routes.

31.1 Configuring Static Routing

Static routes tell the Switch how to forward IP traffic when you configure the TCP/
IP parameters manually.
Click IP Application > Static Routing in the navigation panel to display the
screen as shown.
Figure 146 IP Application > Static Routing
The following table describes the related labels you use to create a static route.
Table 91 IP Application > Static Routing
LABEL
Active
Name
Destination
IP Address
XGS-4728F User's Guide
DESCRIPTION
This field allows you to activate/deactivate this static route.
Enter a descriptive name (up to 10 printable ASCII characters) for
identification purposes.
This parameter specifies the IP network address of the final destination.
Routing is always based on network number. If you need to specify a route
to a single host, use a subnet mask of 255.255.255.255 in the subnet
mask field to force the network number to be identical to the host ID.
31

Static Route

273