Load Factory Default; Save Configuration - ZyXEL Communications XGS-4728F User Manual

Chapter 39 Maintenance
Table 119 Management > Maintenance (continued)
LABEL
Save
Configurati
on
Reboot
System

39.2 Load Factory Default

Follow the steps below to reset the Switch back to the factory defaults.
In the Maintenance screen, click the Click Here button next to Load Factory
1
Default to clear all Switch configuration information you configured and return to
the factory defaults.
Click OK to reset all Switch configurations to the factory defaults.
2
Figure 198 Load Factory Default: Start
In the web configurator, click the Save button to make the changes take effect. If
3
you want to access the Switch web configurator again, you may need to change
the IP address of your computer to be in the same subnet as that of the default
Switch IP address (192.168.1.1).

39.3 Save Configuration

Click Config 1 to save the current configuration settings permanently to
Configuration 1 on the Switch.
330
DESCRIPTION
Click Config 1 to save the current configuration settings to Configuration
1 on the Switch.
Click Config 2 to save the current configuration settings to Configuration
2 on the Switch.
Click Config 1 to reboot the system and load Configuration 1 on the
Switch.
Click Config 2 to reboot the system and load Configuration 2 on the
Switch.
Note: Make sure to click the Save button in any screen to save your
settings to the current configuration on the Switch.
XGS-4728F User's Guide