Switch Access And Login - ZyXEL Communications XGS-4728F User Manual

Chapter 49 Troubleshooting
Turn the Switch off and on (in DC models or if the DC power supply is connected in
1
AC/DC models).
Disconnect and re-connect the power adaptor or cord to the Switch (in AC models
2
or if the AC power supply is connected in AC/DC models).
If the problem continues, contact the vendor.
3
One of the LEDs does not behave as expected.
Make sure you understand the normal behavior of the LED. See
1
page 41.
Check the hardware connections. See
2
Inspect your cables for damage. Contact the vendor to replace any damaged
3
cables.
Turn the Switch off and on (in DC models or if the DC power supply is connected in
4
AC/DC models).
Disconnect and re-connect the power adaptor or cord to the Switch (in AC models
5
or if the AC power supply is connected in AC/DC models).
If the problem continues, contact the vendor.
6

49.2 Switch Access and Login

I forgot the IP address for the Switch.
The default in-band IP address is 192.168.1.1.
1
Use the console port to log in to the Switch.
2
Use the MGMT port to log in to the Switch, the default IP address of the MGMT
3
port is 192.168.0.1.
If this does not work, you have to reset the device to its factory defaults. See
4
Section 4.6 on page
388
Section 3.1 on page
52.
Section 3.3 on
35.
XGS-4728F User's Guide