Arp Inspection Vlan Configure - ZyXEL Communications XGS-4728F User Manual

Table 84 ARP Inspection Port Configure (continued)
LABEL
Burst interval
(seconds)
Apply
Cancel

26.7.2 ARP Inspection VLAN Configure

Use this screen to enable ARP inspection on each VLAN and to specify when the
Switch generates log messages for receiving ARP packets from each VLAN. To
open this screen, click Advanced Application > IP Source Guard > ARP
Inspection > Configure > VLAN.
Figure 132 ARP Inspection VLAN Configure
The following table describes the labels in this screen.
Table 85 ARP Inspection VLAN Configure
LABEL
VLAN
Start VID
End VID
XGS-4728F User's Guide
DESCRIPTION
The burst interval is the length of time over which the rate of ARP
packets is monitored for each port. For example, if the Rate is 15
pps and the burst interval is 1 second, then the Switch accepts a
maximum of 15 ARP packets in every one-second interval. If the
burst interval is 5 seconds, then the Switch accepts a maximum of
75 ARP packets in every five-second interval.
Enter the length (1-15 seconds) of the burst interval.
Click Apply to save your changes to the Switch's run-time
memory. The Switch loses these changes if it is turned off or loses
power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done
configuring.
Click this to reset the values in this screen to their last-saved
values.
DESCRIPTION
Use this section to specify the VLANs you want to manage in the
section below.
Enter the lowest VLAN ID you want to manage in the section
below.
Enter the highest VLAN ID you want to manage in the section
below.
Chapter 26 IP Source Guard
253