Clustering Management Configuration - ZyXEL Communications 43222612 User Manual

Table 228 Management > Cluster Management Status (continued)
LABEL
Model
Status

51.3 Clustering Management Configuration

Use this screen to configure clustering management. Click Management > Cluster Management >
Configuration to display the next screen.
Figure 333 Management > Cluster Management > Configuration
The following table describes the labels in this screen.
Table 229 Management > Cluster Management > Configuration
LABEL
Clustering Manager
Active
Name
DESCRIPTION
This field displays the model name.
This field displays:
Online (the cluster member Switch is accessible)
Error (for example the cluster member Switch password was changed or the Switch was set as
the manager and so left the member list, and so on)
Offline (the Switch is disconnected – Offline shows approximately 1.5 minutes after the link
between cluster member and manager goes down)
DESCRIPTION
The following fields relate to configuring the cluster manager.
Select Active to have this Switch become the cluster manager switch. A cluster can only
have one manager. Other (directly connected) switches that are set to be cluster
managers will not be visible in the Clustering Candidates list. If a switch that was previously a
cluster member is later set to become a cluster manager, then its Status is displayed as Error
in the Cluster Management Status screen and a warning icon (
summary list below.
Type a name to identify the Clustering Manager. You may use up to 32 printable characters
(spaces are allowed).
GS2220 Series User's Guide
435
) appears in the member