Configure Multiple Rapid Spanning Tree Protocol - ZyXEL Communications XGS-4728F User Manual

Chapter 13 Spanning Tree Protocol
13.6 Configure Multiple Rapid Spanning Tree
Protocol
To configure MRSTP, click MRSTP in the Advanced Application > Spanning
Tree Protocol screen. See
MRSTP.
Figure 72 Advanced Application > Spanning Tree Protocol > MRSTP
The following table describes the labels in this screen.
Table 30 Advanced Application > Spanning Tree Protocol > MRSTP
LABEL
Status
Tree
Active
136
Section 13.1 on page 125
DESCRIPTION
Click Status to display the MRSTP Status screen (see
page 134).
This is a read only index number of the STP trees.
Select this check box to activate an STP tree. Clear this checkbox to
disable an STP tree.
Note: You must also activate Multiple Rapid Spanning Tree in the
Advanced Application > Spanning Tree Protocol >
Configuration screen to enable MRSTP on the Switch.
for more information on
Figure 71 on
XGS-4728F User's Guide