Table of Contents
Advertisement
50
GETTING TO KNOW YOUR VEHICLE
4. Place the bracket bushing behind the mirror bracket
(over the cowl bolt hole), then insert the bracket bolt
into the mirror bracket, through the bracket bushing.
Attaching Mirror Bracket To The Vehicle
1 — Bracket Bushing
2 — Bracket Bolt
5. Insert the hinge shoulder bolt through the bottom of
the upper door hinge up into the mirror bracket,
then rotate the bracket knob toward the rear of the
vehicle to secure the mirror bracket to the A-pillar.
Attaching Mirror Bracket To The Vehicle
1 — Bracket Knob
2 — Hinge Shoulder Bolt
6. Tighten both the bracket bolt and the hinge shoul-
der bolt with a #40 Torx head driver. Recommended
torque specification for the bracket bolt is 6 ft-lb
(8 N·m), and 7.5 ft-lb (10 N·m) for the hinge shoulder
bolt.
7. Lower the mirror assembly onto the mirror bracket.
Lower Mirror Assembly Onto Bracket
8. Insert the three mirror screws into the mirror assem-
bly, and tighten into the mirror bracket using a
#30 Torx head driver. Recommended torque specifi-
cation for the mirror screws is 4 ft-lb (5.5 N·m).
Mirror Screw Locations
9. Repeat the steps on the other side of the vehicle.
NOTE:
If this kit is being installed with the optional lamp
bracket, the bracket bushing from step 4 is not needed.
Use the spacer from the lamp bracket.
HALF-DOOR INSTALLATION —
IF EQUIPPED
CAUTION!
•
Do not run half-doors through an automatic car
wash. This may result in scratches and wax
buildup on the windows.
(Continued)
Advertisement
Table of Contents
