Display Of Detailed Information On A Past Trip - Toshiba TOSVERT VF-MB1 Instruction Manual

(Continued)
Item displayed
Note 8 Parts replacement
alarm information
Cumulative
Note 9
operation time
Number of starting
Default display
mode
8.2.2
Details on a past trip (of trips 1 to 8) can be displayed, as shown in the table below, by pressing the center of the
8
setting dial when the trip record is selected in the status monitor mode.
Unlike the "Display of trip information at the occurrence of a trip" in 8.3.2, details on a past trip can be displayed,
even after the inverter is turned off or reset.
Item displayed
Note 10
Past trip 1
Continuous trips
Output frequency
Direction of
rotation
Frequency
Note 1
command value *
Note 2 Output current
Refer to page H-8 for notes.
Panel LED
operated display
m }}}}i



MODE

Display of detailed information on a past trip

Panel
LED display
operated


6



Communic
ation No.
The ON/OFF status of each of the cooling fan,
circuit board capacitor, main circuit capacitor of
parts replacement alarm, cumulative operation
time or number of starting are displayed in bits.
ON: 
m
OFF: 
FE79
Number of starting
Cumulative
operation time
Main circuit
capacitor
The cumulative operation time is displayed.
FE14
(0.1=10 hours, 1.00=100 hours)
FD32 Number of starting (10000 times)
The output frequency is displayed (Operation at
60Hz).
Past trip 1 (displayed alternately)
For oca, ocl and err5 the number of times
(maximum of 31) the same trip occurred in succession is
displayed (unit: times). Detailed information is recorded at
the beginning and ending numbers.
The output frequency when the trip occurred is displayed.
The direction of rotation when the trip occurred is displayed.
(: Forward run, : Reverse run)
The frequency command value when the trip occurred is
displayed.
The inverter output current when the trip occurred is
displayed. (%/A)
H-4
E6581697
Description
}}}}
i
Cooling fan
Control circuit board
capacitor
Description
(Continued overleaf)