Iat Sensor Inspection; Iat Sensor Removal And Installation; To Sensor Inspection; To Sensor Removal And Installation - Suzuki DL650K5 Service Manual

4-50 FI SYSTEM DIAGNOSIS

IAT SENSOR INSPECTION

The intake air temperature sensor is installed on the right side of
the air cleaner box. ("4-33)
IAT SENSOR REMOVAL AND INSTALLA-
TION
• Lift and support the fuel tank. ("5-7)
• Remove the IAT sensor from the air cleaner box.
• Install the IAT sensor in the reverse order of removal.
$ IAT sensor: 18 N·m (1.8 kgf-m, 13.0 lb-ft)

TO SENSOR INSPECTION

TO SENSOR REMOVAL AND INSTALLATION

The tip over sensor is located in under the seat. ("4-35)
• Remove the right frame cover. ("7-5)
• Remove the TO sensor from the rear fender.
• Install the TO sensor in the reverse order of removal.
NOTE:
When installing the TO sensor, the "UP" mark A must be
pointed upward.

STP SENSOR INSPECTION

STP SENSOR REMOVAL AND INSTALLA-
TION
The secondary throttle position sensor is installed at the left side
of the No.2 throttle body.
• Remove the air cleaner box. ("5-15)
• Remove the STP sensor. ("5-19)
• Install the STP sensor in the reverse order of removal.
$ STP sensor mounting screw: 2.0 N·m (0.2 kgf-m, 1.5 lb-ft)

STP SENSOR ADJUSTMENT

• Adjust the STP sensor. ("5-28)

HO2 SENSOR INSPECTION (E-02, 19)

HO2 SENSOR REMOVAL AND INSTALLA-
TION
The HO2 sensor is installed at the exhaust pipe.
• Remove the seat. ("7-4)
• Disconnect the HO2 sensor lead wire coupler and remove the
HO2 sensor.
• Install the HO2 sensor in the reverse order of removal.
$ HO2 sensor: 47.5 N·m (4.75 kgf-m, 34.3 lb-ft)