Inspection - Suzuki DL650K5 Service Manual

INSPECTION

BATTERY CURRENT LEAKAGE
• Remove the seat. (!7-4)
• Turn the ignition switch to the OFF position.
• Disconnect the battery - lead wire.
Measure the current between - battery terminal and the - bat-
tery lead wire using the multi circuit tester. If the reading
exceeds the specified value, leakage is evident.
# 09900-25008: Multi circuit tester set
$ Battery current (leak): 3 mA and less
% Tester knob indication: Current (&, 20 mA)
"
* Because the current leak might be large, turn the
tester to high range first to avoid tester damage.
* Do not turn the ignition switch to the "ON" position
when measuring current.
When checking to find the excessive current leakage, remove
the couplers and connectors, one by one, checking each part.
REGULATED VOLTAGE
• Remove the seat. (!7-4).
• Start the engine and keep it running at 5 000 r/min. with the
dimmer switch turned HI position.
Measure the DC voltage between the + and - battery termi-
nals using the multi circuit tester. If the voltage is not within the
specified value, inspect the generator and regulator/rectifier.
(!8-10 and 8-11)
NOTE:
When making this test, be sure that the battery is in fully-
charged condition.
# 09900-25008: Multi circuit tester set
' Tester knob indication: Voltage (&)
$ Charging output (Regulated voltage):
14.0 – 15.5 V at 5 000 r/min.
ELECTRICAL SYSTEM 8-9
V