Suzuki DL650K5 Service Manual page 346

7-70 CHASSIS
• Assemble the insulator 4 and shim 5 to the new brake pad
6.
#
Replace the brake pads as a set, otherwise braking
performance will be adversely affected.
• Install the new brake pads.
NOTE:
Make sure that the detent of the pad is seated onto the retainer
on the caliper bracket.
• Tighten the caliper mounting bolt 7 and pad mounting pin 8
to the specified torque.
! Rear brake caliper mounting bolt:
Rear brake pad mounting pin:
• Install the plug 9 to the specified torque.
! Pad pin plug: 2.5 N·m (0.25 kgf-m, 1.8 lb-ft)
NOTE:
After replacing the brake pads, pump the brake pedal several
times in order to operate the brake correctly and then check the
brake fluid level.
22 N·m (2.2 kgf-m, 16.0 lb-ft)
17 N·m (1.7 kgf-m, 12.5 lb-ft)