Tps Adjustment - Suzuki DL650K5 Service Manual

4-16 FI SYSTEM DIAGNOSIS
CODE MALFUNCTION PART
C00 None
C12 Crankshaft position sensor (CKPS)
C13 Intake air pressure sensor (IAPS)
C14 Throttle position sensor (TPS)
C15 Engine coolant temperature sensor (ECTS)
C21 Intake air temperature sensor (IATS)
C23 Tip over sensor (TOS)
C24 Ignition signal #1 (IG coil #1)
C25 Ignition signal #2 (IG coil #2)
C28 Secondary throttle valve actuator (STVA)
C29 Secondary throttle position sensor (STPS)
C31 Gear position signal (GP switch)
C32 Fuel injector signal #1
C33 Fuel injector signal #2
C41 Fuel pump control system (FP control system)
C42 Ignition switch signal (IG switch signal)
C44 Heated oxygen sensor (HO2S)
C49 PAIR control solenoid valve
In the LCD (DISPLAY) panel, the malfunction code is indicated from small code to large code.

TPS ADJUSTMENT

1. Warm up the engine and adjust the engine idle speed to
1 300 ± 100 rpm. ("2-15)
2. Stop the engine.
3. Connect the special tool (Mode select switch) and select the
dealer mode.
4. If the throttle position sensor adjustment is necessary, loosen
the screws and turn the throttle position sensor and bring the
line to middle.
5. Then, tighten the screw to fix the throttle position sensor.
$ TP sensor mounting screw: 3.5 N·m (0.35 kgf-m, 2.5 lb-ft)
A Incorrect
B Correct position
! 09930-11950: Torx wrench
09930-82720: Mode select switch
REMARKS
No defective part
Pick-up coil signal, signal generator
For #1 cylinder
For #2 cylinder
For #1 cylinder
For #2 cylinder
Fuel pump, Fuel pump relay
Anti-theft
For E-02, 19