Suzuki DL650K5 Service Manual page 188

4-24 FI SYSTEM DIAGNOSIS
Step2
1) Disconnect the CKP sensor coupler.
2) Crank the engine a few seconds with the starter motor, and
measure the CKP sensor peak voltage at the coupler.
% CKP sensor peak voltage: 3.7 V and more
3) Repeat the above test procedure a few times and measure
the highest peak voltage.
If OK, then measure the CKP sensor peak voltage at the
ECM terminals. (P – T)
! 09900-25008: Multi circuit tester set
' Tester knob indication: voltage (()
Is the voltage OK?
• B/W or White wire open or shorted to ground, or
poor P or T connection.
• If wire and connection are OK, intermittent trou-
YES
ble or faulty ECM.
• Recheck each terminal and wire harness for
open circuit and poor connection.
• Loose or poor contacts on the CKP sensor cou-
NO pler or ECM coupler.
• Replace the CKP sensor with a new one.
(+ White – - Green)
2
2
V