Suzuki DL650K5 Service Manual page 158

3-104 ENGINE
• Apply engine oil to the camshaft journal holders.
• Install the camshaft journal holders, intake and exhaust.
• Fasten the camshaft journal holders evenly by tightening the
camshaft journal holder bolts sequentially and diagonally.
NOTE:
* Align the flange E of the camshafts with the groove F of the
camshaft journal holders.
* Damage to head or camshaft journal holder thrust surfaces
may result if the camshaft journal holders are not drawn down
evenly.
* Each camshaft journal holder is identified with a cast-on letter
G .
• Tighten the camshaft journal holder bolts to the specified
torque.
$ Camshaft journal holder bolt: 10 N·m
#
The camshaft journal holder bolts are made of a spe-
cial material and much superior in strength, compared
with other types of high strength bolts.
Take special care not to use other types of bolts
instead of these special bolts. To identify these bolts,
each of them has a figure "9" on its head.
• Recheck the rear camshaft positions, intake and exhaust.
Cam chain tension adjuster
• Install the cam chain tension adjuster. (!3-101)
• Install the cam chain guide 1.
• After installing the rear camshafts, rotate the generator rotor
(same turns), and recheck the positions of the camshafts.
(1.0 kgf-m, 7.0 lb-ft)