Suzuki DL650K5 Service Manual page 608

13-104 DL650K7/AK7 ('07-MODEL)
DTC "35" (C1635): ABS MOTOR MALFUNCTION
POSSIBLE CAUSE
Motor relay circuit open or short, broken fuse for motor relay,
pump motor circuit open or short, faulty motor relay, faulty ABS
motor, faulty ABS control unit, etc.
Step 1
1) Inspect if the pump motor makes turning noise by setting the
ignition switch to ON from OFF when the vehicle stands still.
Does the pump motor make any turning noise?
Faulty HU motor
YES
Replace the ABS control unit/HU.
NO Go to step 2.
Step 2
1) Remove the seat. (!DL650K4 7-4)
2) Inspect the ABS motor fuse.
ABS motor fuse: 40 A
Is the ABS motor fuse OK?
YES Go to step 3.
NO Replace the ABS motor fuse.
%
If a fuse is blown, find the cause of the problem and
correct it before replacing the fuse.
Step 3
1) Turn the ignition switch to OFF.
2) Remove the ABS control unit/HU cover. (!Page 84)
3) Check the ABS control unit coupler for loose or poor con-
tacts. If OK, then disconnect the ABS control unit coupler.
4) Measure the voltage between 2 terminal and 1 terminal at
the coupler.
$ Normal value: Battery voltage (12.0 V and more)
# 09900-25008: Multi-circuit tester set
' Tester knob indication: Voltage (()
Is the voltage between 2 and 1 normal?
YES Replace the ABS control unit/HU.
Inspect the wire harness. (Faulty motor power
NO
supply or ground wire)
ABS control unit coupler (Harness end)