Suzuki DL650K5 Service Manual page 77

• Remove the cylinder head gasket 5, dowel pins 6 and cam
chain guide 7.
FRONT CYLINDER
• Remove the cylinder nuts 1.
• Remove the cylinder 2.
• Remove the cylinder base gasket 3 and dowel pins 4.
NOTE:
Make sure that the oil jet is inserted in the crankcase.
FRONT PISTON
• Place a clean rag over the cylinder base so as not to drop the
piston pin circlip into the crankcase.
• Remove the piston pin circlip 1.
• Remove the piston 2 by driving out the piston pin.
NOTE:
Scribe the cylinder number on the head of the piston.
REAR CAMSHAFTS
• Rotate the generator 360 degrees (1 turn) counterclockwise
and align the "F" line A on the generator rotor with the index
mark B of the valve timing inspection hole.
ENGINE 3-23