Ignition System; Inspection - Suzuki DL650K5 Service Manual

IGNITION SYSTEM

INSPECTION

IGNITION COIL PRIMARY PEAK VOLTAGE
• Disconnect all the spark plug caps. (!Page 12)
• Connect new spark plugs to each spark plug cap and ground
them on the cylinder.
NOTE:
Be sure that all the spark plugs are connected properly and the
battery used is in fully-charged condition.
Measure ignition coil primary peak voltage (for #1 cylinder) in
the following procedure.
• Insert the needle pointed probe A to the lead wire coupler (for
B/W wire).
%
Use the special tool, to prevent the rubber of the water
proof coupler from damage.
# 09900-25009: Needle pointed probe set
• Connect the multi-circuit tester with the peak voltage adaptor
as follows.
Ignition coil (for #1cylinder):
B/W wire (+ Probe) – Ground (- Probe)
NOTE:
Do not disconnect the ignition coil primary lead wire.
# 09900-25008: Multi-circuit tester set
%
Before using the multi-circuit tester and peak voltage
adaptor, refer to the appropriate instruction manual.
DL650K7/AK7 ('07-MODEL)
Peak volt adaptor
Ignition coil
W/Bl B/W
ECM
New spark plugs
Battery
13-65