Krds Set Up - Konica Minolta 7020 Service Manual

HOME
KRDS
[4]

KRDS Set Up

1. KRDS set up item
KRDS set up procedure
Step
Operation procedure
1 In case of a modem using, turn off the modem and
connect to the copier using a modem cable (RS-232C,
25P-25P straight cable) and wall jack using a modular
cable to the modem.
If the FAX KRDS is used, connect the FAX board
to the wall jack using the modular cable.
2 Setting the KRDS connection recognition
(25 mode → [1. Software SW])
Set copier software DIPSW 12-6 (KRDS
connection recognition) to "1".
Initialize KRDS memory. (47 mode → [1] [5] [
3
] → Start button ON)
[9] [8] [
3
*
4 Set KRDS software SW.
(25 mode → [9. KRDS setting] → [4. KRDS software
SW set] (Select type of modem and dial mode))
Select the type of modem from the bit pattern 0
to 6 of the KRDS software SW No.1 and dial
mode from the bit pattern 7.
5
Host password setting.
(25 mode → [9. KRDS setting] → [2. Host password
set]) (Refer to *1 and *2)
KRDS phone number setting.
6
(25 mode → [9. KRDS setting] → [3. KRDS TEL
No. setting]) (Refer to *3)
Turn off the SW1 (main power) and SW2 (sub
7
power) of the copier.
Turn on the power switch of the modem.
8
9
Turn on the SW1 (main power) of the copier.
10 Check the set up flag setting condition.
(25 mode → [9. KRDS setting] → [4. KRDS software
SW set] → check that the data on the switch No.33
and bit No.0 indicates "0" (not yet).)
Check the KRDS communication mode.
11
(25 mode → [9] KRDS Setting → [4] KRDS
software SW setting → Check the data in bit
No. 2 of switch No. 38.)
It should be set on "1" if communications are via FAX-
KRDS, and on "0" if communications are via a modem.
If the setting is different, change the setting.
12 Preform KRDS set up calling.
(25 mode → [9. KRDS setting] → [5. KRDS Setup calling])
Press the [START] key to start set up.
13
14
Check the finishing of set up.
(25 mode → [9. KRDS setting] → [4. KRDS software
SW set] → Completes if the data on the switch No.33
and bit No.0 indicates "1" (finished).)
15 Turn off the SW1 (main power) and SW2 (sub
power) of the copier.
*1: Host password must be 5-digit.
*2: Host password 1 must be specified.
*3: For both the copier and the host side, copier
phone number and host phone number 1 must be
specified.
*4: Refer to the manual of the modem about
specifications for connecting with the modular
cable.
Wall jack
]
*
Note: In the case of FAX KRDS, connect to the
LINE terminal on the FAX board.
6-2
TEL LINE
Modem
Modular cable