Running Test Mode - Konica Minolta 7020 Service Manual

HOME
7. Resetting standard data
Reset the adjusted set values of timing adjustment to
the standard values (factory default data).
Select the [2. Timing adj.] in the 36 mode menu
screen, then the timing adjustment menu screen will
appear.
Select the [7. Factory default] on this screen, then the
resetting standard data screen will appear.
This adjustment can reset the following item adjusted
set values to the standard values (factory default
data). These can be selected by pressing the [NEXT]
or [BACK] key.
• Factory default --- Vertical/Horizontal magnifica-
• Factory default --- Restart timing adjustment
• Factory default --- Paper feed loop amount adjust-
• Factory default --- Leading edge original erasure
• Factory default --- Centering adjustment
• Factory default --- Original read point adjustment
Step
1 Enter the 36 mode.
2 [36 mode menu screen]
Press the [2. Timing adj.] key.
3 [Timing adjustment menu screen]
Press the [7. Factory default] key.
4 [Resetting standard data screen]
Press the [NEXT] key until the desired item
appears in the message display area.
5 Press the [YES] key to reset the set values
2
to the standard values that have been selected
and to return to timing adjustment menu screen.
Press the [NO] or [RETURN] key, then the set
values are not reset and return to timing
adjustment menu screen.
6 To reset another adjustment item, repeat
steps 4 to 5.
7 Press the [RETURN] key to return to the timing
adjustment menu screen.
tion adjustment
ment
adjustment
Operation procedure
[4]

Running Test Mode

Select the [3. Running mode] in the 36 mode menu
screen, then the running test mode menu sreen will
appear.
The following items can be selected:
1. Running mode 1 (Intermittent copy mode)
Running mode 1 is an intermittent copy mode. In this
mode, after the set number of copy operations has
been completed, the machine goes into the copy
ready status, waits 0.5 sec., then starts the same
operation again.
2. Running mode 2 (Paperless intermittent
copy mode)
Running mode 2 is a paperless intermittent copy
mode. It makes copies at roughly the same timing as
for a normal copy, without performing paper detection
or jam detection. Also, like running mode 1, after the
set number of copy operations has been completed,
the machine goes into the copy ready status, waits
0.5 sec., then starts the same operation again.
3. Running mode 3 (Paperless mode)
Running mode 3 is a paperless mode. It makes
copies at roughly the same timing as for a normal
copy, without performing paper detection or jam
dection.
4. Running mode 4 (Paperless/endless mode)
Running mode 4 is a paperless/endless mode. It
automatically sets the copy quantity to infinity. Also,
like running mode 3, it makes copies at roughly the
same timing as for a normal copy, without performing
paper detection or jam detection.
5. Running mode 5
Running mode 5 is process running mode. It consists
of running mode 4 plus an operation consisting of an
optics each-time scan and an automatic paper feed
tray change.
4-51
ADJUSTMENT
36