Konica Minolta 7020 Service Manual page 268

HOME
KRDS
8. Calling KRDS set up
<Auto set up>
In the host call setting, call the designated host computer
in the set date and time, and transmit each data of the
copier. Refer to the separate KRDS Host Application
Manual for details of the data being handled.
(1) Screen selection
Select the [9. KRDS setting] in the 25 mode menu
screen to display the KRDS setting menu screen.
Then select the [4. KRDS software SW set] to display
the KRDS software SW set screen.
Check that the software DIP SW 33-0 is set to "0".
After checking, press the [RETURN] key to return to
the KRDS setting menu screen.
On the KRDS setting menu screen, select the [5.
KRDS Setup calling] to display the calling host for
setup screen.
Note: If the KRDS software DIPSW 33-0 (Set up
flag) is not selected to "0" (not yet). The
KRDS setup calling screen can not be
selected.
(2) Setting method
a. Press the [Start] key in the screen.
(a) Communication message
Calling the host for setup
Communicating
Note: Do not turn OFF the power during
communication.
(b) Completion message
Calling the host for setup
Communication completed
b. Turn off the power if no completion message is
displayed in ten minutes.
Check that the host computer starting up correct,
host phone number, cable connection, etc. then
open to calling the host for setup screen again to
press the [Start] key.
c. Turn off the power to end the operation.
Step Operation procedure
1 Enter the 25 mode.
2 [25 mode menu screen]
Press the [9. KRDS setting ] key.
3 [KRDS setting menu screen]
Press the [4. KRDS software SW set] key.
4 [KRDS software SW set screen]
Use the [ ] , [
to "33" and bit number "0".
5 Check that bit data indicates "0". If not, set to "0"
to press the [OFF] key.
6 Press the [RETURN] key to return to the KRDS
setting menu screen.
7 [KRDS setting menu screen]
Press the [5. KRDS Setup calling] key.
8 [Calling the host for setup screen]
Press the [Start] key.
Check the message on the screen.
9 Turn off the power to end the operation.
• How to confirm the completion of setup
Confirm the data at bit No. 0 of address 33 in
reference to "4. Setting KRDS software DIP SW."
If "0", setup is not completed.
If "1", setup is completed.
<Manual set up>
This copier machine can be set up manually, other
than the automatical setup as explained above. (The
setup is effective when both the copier and the host
have completed the setup action.)
• Operation for the copier machine
1. Switch on the power of modem.
2. Set the address No. 33 as referring to "4. Setting
KRDS software DIP SW."
3. Change the data of bit No. 0 from 0 to 1.
0: Set up not completed
1: Set up completed
4. Establish the changed data by pressing the copy
button.
5. Switch off the power of main body.
• Operation for the host computer
For the operation of the host compouter, refer to the
KRDS Host Application Administrator's Manual.
6-12
] key to select the switch number