List Print - Konica Minolta 7020 Service Manual

HOME
36
ADJUSTMENT
[8]

List Print

Select the [7. List Print] from the 36 mode menu screen to
display the list print menu screen.
You can select following menu options from this screen.
1. Test pattern.
2. Font pattern.
3. Memory dump list.
4. Management list.
5. Adjustment list.
6. Log list. (1)
7. Log list. (2)
8. Analysing list (Other than 7020/25/30/35)
3
Note: Don't try to touch a mode not mentioned.
1. Test pattern
This option is used to output a grid pattern consisted
of line width of 2 dots and line-to-line space of 500
dots. From this pattern, you can check the write
system for normal performance.
2. Font pattern
This option outputs the font list built in the engine.
3. Memory dump list
This option is used to dump out data (in HEX and
ASCII format) after the address specified in ERDH
memory (this list is referenced for troubleshooting).
4. Management list
This option outputs the machine status, counter
information and history of jam and so on.
5. Adjustment list
This option outputs a list of current adjusting values in
the 25/36 mode.
6. Log list (1)
The data from the memory is dumped in the HEX
format and the ASCII format. (for analyzing trouble)
Normally not used.
Note: In the case of 7020/25/30/35, the key No.
3
of log list (1) is "7".
7. Log list (2)
The data from the memory is dumped in the HEX
format and the ASCII format. (for analyzing trouble)
Normally not used.
Note: In the case of 7020/25/30/35, the key No.
3
of log list (2) is "8".
8. Analysing list
3
Outputs the necessary list prints together if trouble
occurs in the field. (for analysing trouble) ...............
Normally not used. (Other than 7020/25/30/35)
Step Operation procedure
1 Enter the 36 mode.
2 [36 mode menu screen]
Press the [7. List print] key.
3 [List print menu screen]
Press the key corresponding to the desired
menu option.
4 [List print screen]
When outputting the memory dump list, specify
the start and end addresses (Note).
5 Press the [Copy] key.
6 [Basic screen]
Press the [START] button to output the list.
7 Press the # button while depressing the
to return to the list print screen.
8 When outputting another list, repeat above
steps 3 to 7.
9 Press the [RETURN] key to return to the list
print menu screen.
Note: The memory dump list is dump output in
both the HEX and ASCII format.
4-58
button
*