Outline; Specifications; Krds Setting - Konica Minolta 7020 Service Manual

HOME
KRDS
[1]

Outline

If a FAX option is installed in this machine, it is not
necessary to connect a modem for KRDS. If a FAX option
is not installed, please connect a data modem for KRDS.
[2]

Specifications

1. Type: Overall control board built-in type.
2. KRDS (Overall control board) Interface between
modem
: RS-232C Compatible
: Baud Rate: Max
3
3. Basic Functions
Auto trouble notification
Operation count auto acquisition
Remote control (machine adjustment data,
rewriting of the counter limit, etc.)
Notification of frequent JAM occurrence
Replenish toner notification
Repair and other call buttons
4. FAX-KRDS*
Communications Speed : Max. 14.4 kbps (V.17)
Modulation Method
* This specification is valid for KRDS host
application version 5.0 or higher versions.
: 115.2 kbps
Default : 38.4 kbps
: (V.17, V.29, V.27ter,
V.27 fallback mode,
V.34)
[3]

KRDS Setting

3
KRDS allows the copy machine to call up the host
computer periodically and also when there is an
abnormality. Also data in the copier can be changed from
the host computer.
KRDS can execute the above functions for the following
data:
a. Data on the copier's status such as total and PM
count.
b. Data on the frequency of the partial copier such as
RADF paper feed count.
c. Data on the copier's error status such as SC (F) /JAM
occurrence code and count.
d. Data on the various adjustments
To use KRDS, set up as follows:
1. Set the KRDS connection recognition.
2. Initialize KRDS memory.
3. Set the type of modem and line.
(If FAX-KRDS is used, this setting is unnecessary.)
4. Enter host password.
5. Set phone number.
KRDS setting menu
1. Calling time set
2. Host password set
3. KRDS TEL No. setting
4. KRDS software SW set
5. KRDS setup calling
6-1
KRDS