[11] Error Code Table - Konica Minolta 7020 Service Manual

HOME

[11] Error Code Table

3
Error code
K00_00
3
K00_01
K00_02
K00_03
K00_04
K00_05
3
K00_06
K00_07
K00_08
3
K00_09
K00_10
3
K00_11
K00_12
K00_13
3
K01_00
K01_01
K01_02
K01_03
K02_00
K02_01
Contents
Connection NG. (NO CONNECT from modem, Time out.)
No response from other party.
(No detection of start text from host after establishing connection.)
Because copying is taking place, it is impossible to write to the
non-volatile memory and the line is cut.
Password does not match.
Serial number does not match.
Syntactical error. (When undefined commands or parameters come.)
Write-in indication on an item for which write-in is impossible.
Unread item error.
Signal reception time-out after detection other party response.
(After communications of start text have ended.)
Serial number registration completed.
Communications error due to generation of carrier OFF.
(NO CARRIER detected from the modem.)
Dial tone is not detected within 5 seconds after setting of
x2 and x4 commands.
Busy signal detected.
No tone detected for 5 seconds after input of @ command.
DTR went to OFF or in OFF state.
Cannot open RS-232C.
Cannot close RS-232C.
Response time-out from RS-232C task.
AT command error.
Initializing NG (MODEM).
Example: Modem initializing command no good.
Redial, repeat reception standby.
Redial, repeat reception standby.
Temporarily stop copying.
Check password.
Check serial number.
Redial.
Re-operation on host side.
Re-operation on host side.
Redial.
Check serial number.
Redial.
Check connection of telephone
line.
Redial.
Redial.
Check modem power source.
Check RS-232C cable connection.
Turn power on copier OFF and ON.
Turn power on copier OFF and ON.
Check modem power source.
Check RS-232C cable connection.
Turn power on copier OFF and ON.
Possibility of modem malfunction
or software bug.
Check modem power source.
Check RS-232C cable connection.
6-19
KRDS
Countermeasure