Db-409/410 Tray Tilt Adjustment - Konica Minolta 7020 Service Manual

HOME
ADJUSTMENT OTHER
47
[5]

DB-409/410 Tray Tilt Adjustment

2
Wire adjustment part
Normal paper feed can't be expected if the tray is
tilted. In such case, adjust the tray and paper feed
roller shaft so that they may be parallel in each other.
Whenever the wire is replaced, this adjustment must
be implemented.
(1) Remove the front cover of the tray.
(2) Loosen a set screw of the wire adjustment part
situated in front side of the tray.
(3) Move the wire adjustment part until the distance from
top of the side plate to the tray top face is equal in
both the front and back sides.
(4) When the adjustment is complete, tighten the set
screw for the wire adjustment part.
Top face of tray
Wire adjustment
part
Set screw
Metal scales
Set screw
4-92