Optional Gsm Module Mounting; Power Cable Connection; Control Panel Final Closure - Visonic POWERMAXEXPRESS - INSTALLATION 2 Installer's Manual

Figure 3.3 - Battery Insertion

3.7 Optional GSM Module Mounting

Note: The GSM module is used with an internal antenna.
Optional external antenna can be used.
Caution: Do not install or remove the GSM module when
the system is powered by AC power or backup battery.
1. Plug in the
GSM Module
and fasten it
as follows:
Figure 3.4 - Optional GSM Module Mounting
2. Insert the SIM card into the GSM module
SIM card insertion
1
Slide top
cover
4 5
Rotate cover
Slide SIM
to close
card into
cover
Figure 3.5 - SIM Card insertion
8
1
Battery
insertion
2
Battery connection
GSM
Front
unit
2 3
Open Align SIM
cover card in cover
(note cover
orientation)
6
Lock cover
IMPORTANT
to close Do not insert or remove
SIM card when the
control panel is powered
by AC power or battery.

3.8 Power Cable Connection

External power connections (Option)
Connect the power cable and close the control panel as
shown below. Electrical socket-outlet shall be installed
near the equipment and shall be easily accessible.
WARNING! DO NOT USE AN OUTLET CONTROLLED
BY A WALL SWITCH.
Note: This equipment should be installed in accordance with
Chapter 2 of the National Fire Alarm Code, ANSI/NFPA 72,
(National Fire Protection Association).
Connect the power
adapter to the
power connector.
Fig. 3.6a - Power Cable Connection
Internal Power Connection (Option)

3.9 Control Panel Final Closure

Control panel final closure is shown below.
Fasten
screws
Figure 3.7 - Final Closure
.
Fig. 3.6b
Internal Power
Cable Connection
.
1
Close
front
cover
D-302989