Dual Rs-232 Optional Module Mounting; Optional Expander Module Mounting; Power Cable Connection - Visonic PowerMaxComplete Installer's Manual

Internal
GSM
antenna
Figure 3.6 - GSM Internal Antenna Mounting
For external antenna only: Connect
antenna to the GSM antenna connector. Verify that the
antenna cable routing enables proper closing of the control
panel.
GSM antenna
connector
Figure 3.7 - GSM External Antenna Connection
3.8 DUAL RS-232 Optional Module
Mounting
The DUAL RS-232 is a Module that enables connection of
any two simultaneous devices, such as Local PC or
external GSM Module.
The external GSM unit enables the PowerMaxComplete
system to operate over a cellular network (for details
regarding the GSM modem features and connections,
refer to the external GSM Modem installation instructions).
To install the DUAL RS-232 module into the control panel,
press it into the marked location (see drawing below) until
a click is heard.
Connect a local PC or external GSM module, to one of the
DUAL RS-232 module connectors, as shown below.
8
Connector
Antenna cable
the external
External
GSM
antenna
DUAL RS-232 MODULE
Figure 3.8 – DUAL RS-232 Module Mounting
3.9 Optional
Mounting
The EXPANDER module enables connection of speech
box, site external siren, site internal siren or strobe and
connection of wired detector to zone number 29 and 30.
The EXPANDER module also enables connection of a
desired device to PGM (programmable) output that is
activated according to a predefined conditions.
Mount the Expander module as shown below.
1
P r e s s t h e
E X P A N D E R
module in the back
panel between its
2 clips.
2 Clips
Figure 3.9 – EXPANDER Module Mounting

3.10 Power Cable Connection

Connect the power cable and close the control panel as
shown in figure 3.10.
Socket-outlet shall be installed near the equipment and
shall be easily accessible.
Connector for PC
Connector for external
GSM or PC
Expander Module
2
C o n n ec t t h e
E x p a n d e r
M o d u l e
cable to the front
p a
E X P A N D E R
receptacle.
The receptacle
with strain relief
clip is for the
front unit - do not
connect to the
back unit!
Strain relief clip
D-300885
f l a t
n e l