Automation Using The 6300'S Internal Clock - Orban OPTIMOD 6300 Operating Manual

OPTIMOD 6300 DIGITAL
C) Program tally output #2 if you wish, following the procedure in step (B) above
with the T

Automation Using the 6300's Internal Clock

1. If you have not already done so, set the system clock.
[You can also set the clock automatically via PC Remote or the Internet. See
Synchronizing Optimod to a Network Time Server starting on page 2-48.]
A) Navigate to S
a) Set hours and minutes.
b) Enter seconds slightly ahead of the correct time.
c) Wait until the entered time agrees with the correct time. Then press the
E T
NTER IME
B) Press the S
a) Set today's date, using the days, month, and year buttons.
b) Press the E
C) Press the D
a) Using the Daylight Saving (DT M
and week when Daylight Saving Time (Summer Time) begins, or O
b) Using the Standard Time (ST M
and week when Daylight Saving Time (Summer Time) ends.
Note that setting DT M
defeat Daylight Time functionality.
c) Press the Escape key to back out of the daylight saving screen.
D) (Optional) Press the S
sign or call letters).
a) Use the knob to select characters. Use the P
the cursor.
b) When you are finished, press S
2. Navigate to Setup > Next > Automation.
If the A
UTOMATION
able automation.
This button allows you to easily enable or disable all automation events without
having to edit individual automation events.
O 2 button.
ALLY UT
> N > T
ETUP EXT IME
button to set the clock.
D
button.
ET ATE
D
button.
NTER ATE
T
button.
AYLIGHT IME
,
ONTH
ID button to specify your station's identifier (call
TATION
button reads D
ISABLED
D A ID > S T
ATE ND ET IME
and DT W
ONTH EEK
and ST W
) buttons, set the month
ONTH EEK
,
DT W ST M , or ST W
EEK ONTH
and N
REV
.
AVE
, hold it down and turn the knob to en-
INSTALLATION
.
) buttons, set the month
.
FF
to O
will
EEK FF
EXT buttons to move
2-39